Golf Mk6
Overview - valve chest |
1 - | ATF inspection plug |
q | Checking ATF level and topping up → Chapter |
q | Torque setting → Chapter |
2 - | Seal |
q | Always renew |
3 - | Overflow pipe |
q | Unscrew to drain ATF |
q | Torque setting → Chapter |
4 - | Oil pan |
q | Removing and installing → Chapter |
5 - | Bolt |
q | Tighten oil pan bolts diagonally in several stages. |
q | Torque setting → Chapter |
6 - | Seal |
q | With spacer sleeves (qty. 8) |
q | Examine before fitting |
q | Renew brittle, cracked or deformed seal |
7 - | Magnet |
q | Qty. 2 in depressions in pan |
q | Clean oil pan before installing |
8 - | Bolt |
q | For securing valve body in gearbox |
q | Qty. 12, various lengths → Fig. |
q | Always renew bolts |
q | Torque setting → Chapter |
9 - | Bolt |
q | Qty. 3 |
q | For securing strainer to valve body |
q | Torque setting → Chapter |
10 - | ATF strainer |
q | Removing and installing → Chapter |
11 - | Valve body |
q | Removing → Chapter |
q | Installing → Chapter |
q | Allocation → Electronic parts catalogue „ETKA“ |
12 - | Bolt |
q | Torque setting → Chapter |
13 - | Bolt |
q | Torque setting → Chapter |
14 - | Gearbox input speed sender -G182- |
q | Removing and installing → Chapter |
15 - | Bolt |
q | Torque setting → Chapter |
16 - | Gearbox output speed sender -G195- |
q | Removing and installing → Chapter |
17 - | Gearbox housing |
q | Shown here without gearbox oil cooler |
18 - | Breather cap |
19 - | Multifunction switch -F125- |
q | Removing → Chapter |
q | Installing → Chapter |
q | Adjusting → Chapter |
20 - | Gearbox oil temperature sender -G93- |
q | Integrated into wiring harness |
q | Torque setting → Chapter |
q | Removing and installing → Chapter |
q | Cable routing → Chapter. |
21 - | Bolt |
q | Torque setting → Chapter |
22 - | Bolt |
q | Torque setting → Chapter |
23 - | Wiring harness for sender |
q | With gearbox oil temperature sender -G93- |
q | For gearbox input speed sender -G182- |
q | For gearbox output speed sender -G195- |
q | Always renew oil seal on housing |
q | Removing and installing → Chapter |
q | Cable routing → Chapter. |
q | Allocation → Electronic parts catalogue „ETKA“ |
24 - | Seal |
q | Always renew |
25 - | ATF drain plug |
q | Torque setting → Chapter |
26 - | Selector lever |
27 - | Washer |
28 - | Nut |
q | Location: centring collar faces washer → Item |
q | Torque setting → Chapter |
29 - | Spring |
q | Allocation → Electronic parts catalogue „ETKA“ |
30 - | Damper piston |
31 - | Wiring harness for solenoid valves |
q | Always renew oil seal on housing |
q | Removing and installing → Chapter |
q | Cable routing → Chapter. |
32 - | Bolt |
q | Torque setting → Chapter |