Golf Mk6
Assembly overview - valve gear |
1 - | 50 Nm + 180° (1/2 turn) further |
q | Renew. |
q | Use counterhold tool -3036- to loosen and tighten. |
2 - | Camshaft pulley |
q | Use counterhold tool -3036- to loosen and tighten. |
3 - | Seal |
q | Renewing → Chapter. |
4 - | Cylinder head |
5 - | Valve guide |
q | Check → Chapter. |
6 - | Valve stem seal |
q | Renewing → Chapter. |
7 - | Valve spring |
8 - | Upper valve spring plate |
9 - | Valve cotter |
10 - | Hydraulic compensation element |
q | Do not interchange. |
q | Oil contact surface. |
11 - | Woodruff key |
q | Check for secure seating. |
12 - | Exhaust camshaft |
q | Check radial clearance with Plastigage (roller rocker fingers removed). Wear limit: 0.1 mm. |
q | Runout: max. 0.035 mm. |
13 - | Retaining frame |
q | With integrated camshaft bearings. |
q | Clean sealing surface; reworking not permitted. |
q | Remove sealant residue. |
14 - | 8 Nm + 1/4 turn (90°) further |
q | Renew. |
15 - | Camshaft adjuster |
q | Removing and installing → Chapter. |
16 - | 20 Nm + 1/8 turn (45°) further |
q | Use counterhold tool -3036- to loosen and tighten. |
17 - | Inlet camshaft |
q | Checking radial clearance with Plastigage; wear limit: 0.1 mm. |
q | Runout: max. 0.035 mm. |
18 - | Chain tensioner |
q | Secure with locking pin -T10115- before removing. |
19 - | Drive chain |
q | Removing and installing → Chapter. |
q | Check for wear. |
20 - | 10 Nm |
21 - | 10 Nm |
22 - | Hall sender -G40- |
23 - | Exhaust valve |
q | Do not rework. Only lapping in is permitted. |
q | Valve dimensions → Chapter. |
q | Checking valve guides → Chapter. |
24 - | Inlet valve |
q | Do not rework. Only lapping in is permitted. |
q | Valve dimensions → Chapter. |
q | Checking valve guides → Chapter. |
25 - | Cap |
q | Renew. |
q | Removing: pierce centre of cap using screwdriver and lever out. |
q | Installing: Do not use sealant. Press in 1…2 mm using thrust piece -3334-. |