Golf Mk6
Overview of fitting locations |
1 - | Charge pressure control solenoid valve -N75- |
q | Installed directly on turbocharger |
2 - | Electrical connector for air mass meter -G70-. |
q | Removing and installing air mass meter -G70- → Chapter. |
3 - | Ignition coils with final output stage |
q | Removing and installing → Chapter. |
q | Ignition coil 1 with output stage -N70- |
q | Ignition coil 2 with output stage -N127- |
q | Ignition coil 3 with output stage -N291- |
q | Ignition coil 4 with output stage -N292- |
q | Pull all ignition coils out of cylinder head using puller -T40039-. |
4 - | Lambda probe -G39- and Lambda probe heater -Z19- |
5 - | Engine control unit -J623- |
q | Removing and installing → Chapter. |
6 - | Fuel pressure sender for low-pressure -G410- |
q | 15 Nm |
7 - | Fuel pressure regulating valve -N276- |
8 - | Inlet camshaft control valve 1 -N205- |
q | Removing and installing → Chapter. |
9 - | High-pressure pump |
q | Removing and installing → Chapter. |
10 - | 6-pin connector |
q | For Lambda probe -G39- and Lambda probe heater -Z19- (black) |
11 - | Coolant temperature sender -G62- |
12 - | Components |
q | Engine speed sender -G28- |
q | Checking oil pressure switch -F1- → Chapter. |
q | 3-pin push-on connector for knock sensor I -G61- |
q | 3-pin push-on connector for knock sensor II -G66- |
13 - | Intake manifold flap motor -V157- and intake manifold flap potentiometer -G336- |
q | After removing or renewing fuel rail, potentiometer for intake manifold flap -G336- must be re-adapted to engine control unit -J623- → Vehicle diagnostic tester»Guided functions« |
q | Removing and installing → Chapter. |
14 - | Activated charcoal filter solenoid valve 1 -N80- |
15 - | Charge air pressure sender -G31- |
16 - | Turbocharger air recirculation valve -N249- |
17 - | Connector |
q | For Hall sender -G40- and fuel pressure sender -G247- |
18 - | 8-pin push-on connector for injectors |
19 - | Throttle valve module -J338-, throttle valve drive for electric throttle operation -G186- |
q | Throttle valve drive angle sender 1 for electric throttle -G187- and throttle valve drive angle sender 2 for electric throttle -G188- |
q | After renewing throttle valve module -J338- it must be re-adapted to engine control unit -J623- → Vehicle diagnostic tester»Guided functions« |
20 - | Intake air temperature sender -G42- |
q | 11 Nm |
21 - | Radiator outlet coolant temperature sender -G83- |
22 - | Fuel pressure sender -G247- |
q | 22 Nm |
q | Removing and installing → Chapter. |
23 - | Hall sender -G40- (camshaft position sensor) |