Golf Mk6
Assembly overview - sump / oil pump, engine codes CBDA, CBDC, CBDB, CJAA |
1 - | 15 Nm |
2 - | Sealing flange |
q | With seal. |
q | Must seat on dowel sleeves. |
q | Removing and installing → Chapter. |
q | Install with silicone sealant -D 176 404 A2-. |
q | Do not additionally oil or grease the oil seal sealing lip. |
q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
3 - | Chain tensioner with tensioning rail, 15 Nm |
q | When installing, pretension spring and fit. |
4 - | Oil dipstick |
q | The oil level must not be above the max. mark! |
q | Markings → Chapter. |
5 - | Piston fitting tool |
6 - | Guide tube |
7 - | Dowel sleeves |
8 - | O-ring |
q | Renew. |
9 - | 15 Nm |
10 - | Suction line |
q | Clean strainer if soiled. |
11 - | Baffle plate |
12 - | 15 Nm |
13 - | 15 Nm |
14 - | Oil sump |
q | Removing and installing → Chapter. |
q | Clean sealing surface before fitting. |
q | Install with silicone sealant D 176 404 A2. |
15 - | Oil drain plug, 30 Nm |
q | Renew. |
16 - | 10 Nm |
17 - | Oil level and oil temperature sender -G266- |
q | Black 3-pin connector |
q | Check → Vehicle diagnostic tester. |
18 - | Seal |
q | Renew. |
19 - | Oil pump |
q | With 12 bar pressure relief valve |
q | Before installing, check that both dowel sleeves for centring oil pump on cylinder block are fitted. |
q | Renew if running surfaces and gears are scored. |
20 - | Chain sprocket for oil pump |
21 - | Bracket |
q | For oil level and oil temperature sender -G266- wiring harness. |
22 - | 20 Nm + turn 90° further |
23 - | Chain |
24 - | 25 Nm |
q | Insert without sealant. |
25 - | Oil spray jet |
q | For piston cooling. |