Golf Mk6
| Assembly overview - engine oil cooler |
| 1 - | Cap |
| q | 25 Nm |
| 2 - | O-ring |
| q | Renew. |
| 3 - | O-ring |
| q | Renew. |
| 4 - | O-ring |
| q | Renew. |
| 5 - | Oil filter element |
| q | See note → Anchor. |
| q | Removing and installing → Booklet808 |
| 6 - | Engine oil cooler |
| q | See note → Anchor. |
| q | Coolant hose schematic diagram → Chapter. |
| q | Removing and installing → Chapter „Removing and installing engine oil cooler“ |
| q | Change coolant after renewing. |
| 7 - | 11 Nm |
| 8 - | Gaskets |
| q | Renew. |
| 9 - | Bolt |
| q | Renew. |
| q | Specified torque and tightening sequence → Fig.. |
| 10 - | Oil filter bracket |
| q | With integrated oil retention valve. |
| q | Removing and installing → Chapter „Removing and installing engine oil cooler“. |
| 11 - | Gaskets |
| q | Renew. |
Note
|
|
| Stage | Bolts | Specified torque/turning further angle |
| 1. | -arrows- | in diagonal sequence, 14 Nm |
| 2. | -arrows- | turn 90° further using diagonal sequence |
