volkswagen Workshop Repair Guides

Volkswagen Golf Workshop Service and Repair Manuals

ABOUT US
B - Attaching assembling toolT10134 with sealing flange on crankshaft flange > < Pressing sealing flange with sender wheel onto crankshaft

Assembling seal with sender wheel on assembly tool T10134

A - Assembling seal with sender wheel on assembly toolT10134
A - Assembling seal with sender wheel on assembly tool -T10134-
   
–  Screw in hexagon nut -B- to just before clamping surface -A- of threaded spindle.
  N13-10023
–  Clamp assembly device -T10134- in a vice on clamping surface -A- of threaded spindle.
–  Press assembly housing -C- downwards so that it lies on hexagon nut -B--arrow-.
–  Screw hexagon nut onto threaded spindle until inner part of assembly device and assembly housing are at same height.
  N13-10024
–  Remove securing clip -arrow- from new sealing flange.
  Note
The sender wheel must not be taken out of the sealing flange or twisted.
  N13-10025
–  Locating hole -A- on sender wheel -C- must align with marking -B- on sealing flange.
–  Place sealing flange with front side downwards on a clean flat surface.
  N13-10026
–  Push sealing lip support ring -A- downwards in direction of arrow until it lies on flat surface.
  N13-0386
–  Upper edge of sender wheel and front edge of sealing flange must align -arrows-.
  N13-10028
–  Place sealing flange with front side on assembly tool -T10134- so that locating pin -B- can be inserted in sender wheel hole -A-.
  Note
Ensure sealing flange lies flat on assembly tool.
  N13-10029
–  Push sealing flange and support ring for sealing lip -B- against surface of assembly tool -T10134- whilst tightening the three knurled screws -A- so that locating pin cannot slide out of sender wheel hole.
  Note
When installing sealing flange, ensure that sender wheel remains fixed in assembly device.
  N13-10030

B - Attaching assembling toolT10134 with sealing flange on crankshaft flange > < Pressing sealing flange with sender wheel onto crankshaft