Volkswagen Workshop Service and Repair Manuals > Golf Mk6 > Power unit | 4-cylinder injection engine (1.4 l direct injection engine, turbocharger and supercharger) | Exhaust system | Exhaust pipes, silencers

Installation position of clamp

Note

Gradual introduction of clamp with continuous clip.

Specified torque and mounting dimensions of clamping sleeve.

Clamp -A- with 2 individual clips.

Specified torque 25 Nm.

Installation dimensions -a- 5 mm (only for front clamp)

Clamp -B- with continuous clip.

Specified torque: 35 Nm.

Installation dimensions -a- 8.5 mm (only for front clamp)

Installation dimension -a- for vehicles with marking -A- on front exhaust pipe

1 -

Clamp

2 -	Front exhaust pipe

3 -	Securing nut

4 -	Securing nut

a -	Installation dimension

A -

Marking

Installation position of front clamp

–	Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

l	Threaded connection faces right.

Installation position of rear clamp

–	Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

l	Threaded connection faces to rear.

Volkswagen Workshop Service and Repair Manuals