volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Checking oil pressure and oil pressure switch > < Removing

Golf Mk6

Installing
Installing
Prerequisite
   
l  One of the follower polygon cams -arrow- on the crankshaft is uppermost.
  N17-0081
–  Fit hexagon socket head bolt of oil seal fitting tool -3083- with assembly tool -T10022- onto crankshaft and tighten hand-tight.
–  Fit new gasket onto dowel sleeves -A-.
  N17-0075
–  Position marking -arrow A- of inner rotor of oil pump at installation position marking -arrow B- on oil pump housing cover.
–  Coat the four crankshaft follower polygon cams with oil.
–  Lightly oil sealing lip of oil pump oil seal.
–  Guide oil pump carefully onto crankshaft follower polygon cams.
–  Align inner rotor to crankshaft follower polygon cams by turning slightly if necessary.
–  Then slide oil pump carefully onto dowel sleeves.
–  Secure oil pump with new bolts. Specified torque: 12 Nm
–  Remove assembly tool -T10022-.
–  Install suction line → Item.
–  Install sump → Chapter.
–  Install main drive tensioning roller → Chapter.
  N17-0074

Checking oil pressure and oil pressure switch > < Removing