volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Installing > < Removing and installing oil pump

Golf Mk6

Removing
Removing
–  First remove main drive toothed belt → Chapter.
   
–  Secure crankshaft toothed belt pulley -1- to crankshaft using old securing screw -2-.
–  Turn crankshaft to TDC No. 1 cylinder.
–  The ground-down tooth on the toothed belt pulley must align with mark on the oil pump -arrow-.
–  Turn crankshaft and toothed belt pulley three teeth anti-clockwise away from TDC.
  N17-0076
Third tooth -arrow- to right of ground-down tooth -A- on toothed belt pulley must align with TDC mark on oil pump housing.
  Note
This adjustment moves the crankshaft to the correct installation position for the oil pump. One of the follower polygon cams on the crankshaft is uppermost.
–  Remove main drive tensioning roller.
–  Remove sump → Chapter.
–  Remove suction pipe → Item.
–  Remove crankshaft toothed belt pulley.
–  Remove oil pump.
–  Remove gasket.
–  Remove sealant remnants on cylinder block with a flat scraper.
–  Clean sealing surfaces. They must be oil and grease free.
  N17-0073

Installing > < Removing and installing oil pump