| Removing and installing reversing camera housing |
Note | The reversing camera in the Golf 6 need not be calibrated. |
| Reversing camera and swivel motor are each installed in individual housings together in swivel badge of rear lid. To remove camera housing, remove first both components together with swivel badge from rear lid. Afterwards, camera housing together with swivel motor can be removed from swivel badge and then camera housing separated from swivel motor. Removal of camera from camera housing is not provided for. |
| t
| Removing and installing swivel badge with reversing camera housing and swivel motor from rear lid → Chapter |
| t
| Removing and installing reversing camera housing with swivel motor out of swivel badge → Chapter |
| t
| Separate reversing camera housing from swivel motor → Chapter |
Note | t
| Depending on equipment, two different versions of reversing cameras are installed. |
| t
| If the reversing camera is replaced, it must be replaced with a new camera of the same type. |
|
|
|
