–
| Remove both securing bolts -2- from swivel motor. |
–
| Carefully separate reversing camera housing from swivel motor. |
Install in the reverse order of removal. When doing this, note the following: |
–
| Check if release lever and sliding surface on swivel motor are sufficiently greased. |
–
| Fit reversing camera housing and swivel motor together. |
–
| Screw in and tighten both securing bolts to 1.6 Nm. |
–
| Clip in swivel motor wire into wire guide behind camera. |
Installing reverse camera housing with swivel motor into swivel badge → Chapter |
|
|
|