New Beetle L4-1.8L Turbo (AWV) (2005)
-
Check wires to control module according to wiring diagram.
Check wires to control module
-
Connect test box to control module wiring harness. connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test
Vehicles with engine code APH, AWP, AWV
-
Check wires between test box and 2-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Terminal 2 + socket 105
Wire resistance: max. 1.5 Ohms
Vehicles with engine code BKF, BNU
-
Check wires between test box and 2-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Terminal 2 + socket 120
Wire resistance: max. 1.5 Ohms
Continue for all vehicles
-
Check the wire for short circuit to B+ and Ground (GND).
Specified value: Infinite Ohms
-
Check wire between 2-pin connector terminal 1 and the Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ohms
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes