New Beetle L4-2.0L (AZG) (2003)
Rear speed sensor wiring, removing and installing
Special tools and equipment
^
VAS 1978 Wiring harness repair kit
Removing:
-
Obtain radio code on vehicles with coded radio.
-
Disconnect battery.
-
Separate speed sensor wiring/speed sensor connection.
-
Remove rear side panel trim.
-
Disconnect speed sensor wiring -arrow- with wire strippers from VAS 1978 and remove faulty wiring.
-
Strip 15 mm (5/8 inch) of insulation from end of wire with wire stripper and fold half of stripped wire back.
-
Guide in new speed sensor wiring.
-
Connect speed sensor to speed sensor wiring.
-
Clip in speed sensor wiring -arrow-.
Make sure the wiring is not twisted when installing the speed sensor wiring in the wheel housing.
-
Cut 2-pin connector off new speed sensor wiring with wire stripper pliers.
-
Strip 15 mm (5/8 inch) of insulation from end of wire with wire strippers and bend back half.
-
Connect speed sensor wiring with help of suitable crimp connector from wiring harness repair kit VAS 1978.