volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling sequence > < Removing and installing gearbox housing and selector mechanism

Passat (B3)

5-Speed manual gearbox 02A
Dismantling and assembling gearbox
Removing and installing input shaft, output shaft (pinion shaft), differential and selector forks
 
N34-0038
  • Differential
    • ◆ Dismantling and assembling
  • Sealing ring
    • ◆ Qty. 4
    • ◆ Always renew
  • Output shaft
    • ◆ Dismantling and assembling => Page 35-19
  • Reverse shaft support
    • ◆ Dismantling and assembling => Page 35-48
 
N34-0038
  • Reverse shaft
    • ◆ Dismantling and assembling => Page 35-47
  • Input shaft
    • ◆ Dismantling and assembling => Page 35-1
  • Selector mechanism
    • ◆ (Selector forks)
    • ◆ Dismantling and assembling
      => Page 34-97
  • Torx socket head bolt, 25 Nm
  • Reverse gear selector fork
    • ◆ Dismantling and assembling
      => Page 34-97
    • ◆ Installation position => Page 34-71
  • Clutch housing
    • ◆ Servicing => Page 34-80
 
N34-0038
  • Hexagon nut, 25 Nm and then turn 90° further
    • ◆ 4 nuts for bearing support
  • Flange shaft
  • Circlip
    • ◆ Always renew
    • ◆ Removing and installing
      => Page 34-79
  • Flange shaft with spring
    • ◆ Complement => Page 39-15
  • Cone head bolt, 25 Nm
    • ◆ Installed in gearboxes with springs behind flange shaft

Dismantling and assembling sequence > < Removing and installing gearbox housing and selector mechanism