Volkswagen Workshop Service and Repair Manuals

Throttle valve positioner (V60) with 6-pin connector

Special tools, testers and auxiliary items

• ◆ Fault reader V.A.G 1551 or vehicle system tester V.A.G 1552 with cable V.A.G 1551/3
• ◆ Hand multimeter V.A.G 1526 or multimeter V.A.G 1715
• ◆ Diode test lamp V.A.G 1527
• ◆ Adapter set V.A.G 1594
• ◆ Current flow diagram

Test conditions

• ● Fuse 15 OK.

Test sequence

• ‒ → Pull back rubber boot on throttle valve positioner (V60) plug.
• ‒ Connect diode test lamp V.A.G 1527 with aux. cables from V.A.G 1594 to contacts 2+4.
• ‒ Initiate final control diagnosis .
  When activating the throttle valve positioner the LED must
       flicker.

If the LED does not flicker:

• ‒ Input 06 for "End output" and confirm with Q.

• ‒ → Pull connector -1- off throttle valve positioner -2-.
• ‒ Connect multimeter with aux. cables from V.A.G 1594 to measure voltage at contacts 3+4 of the connector.
       Specification: approx. battery voltage
• ‒ Switch off ignition

If the specification is not obtained:

• ‒ Check contact 3 wiring according to current flow diagram.
• ‒ Carry out electrical check, test step 18
  => Page 01-20 , if necessary renew throttle valve positioner (V60).