Passat Sedan V6-3.6L (BLV) (2008)
-
Lubricate the running surfaces of both camshafts.
-
Place the respective camshaft carefully in the camshaft bearings of the cylinder head. While doing so, observe the identification of the camshafts.
Refer to => [ Camshaft Identification ] See: Application and ID.
-
Observe the installed position of the bearing caps.
Installed Position of Camshaft Bearing Caps
The points - arrow A - on the intake and exhaust camshaft bearing caps face outward.
A - Intake Camshaft
-
Tighten bearing caps 5 and 9 alternately in a diagonal sequence to 5 Nm + 45° (1/8) additional turn.
-
Install bearing caps 1 and 13 and tighten to 5 Nm + 45° (1/8) additional turn.
-
Install bearing caps 7 and 13 and tighten to 5 Nm + 45° (1/8) additional turn.