Passat Sedan V6-3.6L (BLV) (2008)
Special tools, testers and auxiliary items required
‹› Assembly Tool (T10118)
‹› 27 mm Open End Adapter, 3/8" Drive
‹› Pressure Sensor Tester (VAS 6394)
‹› Test Instrument Adapter/DSO (3 pin) (VAS 5570)
CAUTION!
‹› The fuel pressure sensor is pressurized. Wear protective goggles and protective clothing to prevent injuries and contact with skin.
Wrap a cloth around the connection point before loosening the fuel pressure sensor. Then release pressure by carefully loosening.
-
Disconnect the connector from the fuel pressure sensor - A - and remove the sensor with an open end wrench.
-
Remove the bolt - 2 - and install the fuel pressure sensor to the (VAS 6394/1). Tightening specification: 22 Nm.
-
Lubricate the (VAS 6294/2) sealing point with clean engine oil and install it in the fuel rail. Tightening specification: 22 Nm.