Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5572

Page 8
background image

-

Determine the path of the faulty antenna wire in the vehicle and measure the total length of antenna wire to be replaced.

The entire length of the antenna wire consists of the length of the required adapter leads - 1 - and - 3 - as well as the connecting wire - 2 -.

-

Subtract 60 cm from the total length calculation for an antenna wire to provide for the required length of connecting wire - 2 - to be installed.

-

Obtain the required adapter leads - 1 - and -  3 - as well as the calculated length of connecting wire -  2 -

-

Cut the connectors off of the faulty antenna wiring.

Leave the rest of the defective antenna wire in the vehicle.

-

Connect adapter leads - 1 - and - 3 - to modules in vehicle.

-

Route and secure connecting wire - 2 - in the immediate vicinity of the series-installed wire routing.

‹› Antenna wires must not be kinked or excessively bent! The bending radius must never be below 50 mm.

-

Connect the connecting wire with the adapter leads.

-

Perform a function test.

Wires With Diameter up to 0.35 mm 2, Repairing

Wires with Diameter up to 0.35 mm 2, Repairing

Special tools, testers and auxiliary items required

‹› Crimping pliers, complete (VAS 1978/1 A)

‹› Exchange head, 0.35mm² - 2.5mm² (VAS 1978/1-1)

Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5572

[PREV PAGE] [NEXT PAGE]