Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5578

Page 14
background image

CAUTION!
When heat-shrinking crimp connections, be careful not to damage any other wiring, plastic parts or insulating material with the hot
nozzle of the hot air gun.

Always observe operating instructions of heat gun.

‹› Make sure that crimp connections do not lie directly next to each other when several wires need to be repaired. Arrange the crimp connectors at a

slight offset so that the circumference of the wiring harness does not become too large.

‹› In the event the repair point was previous taped, this point must be taped anew with yellow insulating tape after repairs.

‹› Secure the repaired wiring harness if necessary with a cable tie to prevent flapping noises while driving.

Wire Break With Dual Repair Point

Wire Break with Dual Repair Point

Repair point with intermediate wire section

Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5578

[PREV PAGE] [NEXT PAGE]