Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Powertrain Management > Computers and Control Systems > Variable Valve Timing Actuator > Component Information > Service and Repair > Camshaft Adjuster With Timing Chain, Installing > Page 3389
If the mark match:
Secure the respective camshaft to be tightened using a 27 mm open end wrench on the recess - arrow -.
‹› The (T10068 A) must not be installed during this process.
‹› Be aware that all sprocket bolts must be replaced.
Tighten the new bolts for the intake and exhaust camshaft adjuster to 60 Nm + 90° (1/4) additional turn.
Install the sealing flange. Refer to => [ Sealing Flange, Transmission Side ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block
|[PREV PAGE] [NEXT PAGE]|