Workshop Manuals Factory service & repair Volkswagen
01 Relays and Modules02 Sensors and Switches03 Maintenance04 Engine, Cooling and Exhaust05 Powertrain Management06 Transmission and Drivetrain07 Brakes and Traction Control08 Starting and Charging09 Power and Ground Distribution10 Steering and Suspension11 Heating and Air Conditioning12 Restraint Systems13 Accessories and Optional Equipment14 Body and Frame15 Cruise Control16 Instrument Panel, Gauges and Warning Indicators17 Lighting and Horns18 Windows and Glass19 Wiper and Washer Systems
Volkswagen Passat Sedan V6-3.6L (BLV) (2008)05 · Powertrain Management
05 · Diagnostics

HO2S Front Oxygen Sensor Bank 1 Sensor 1, Checking (page 31 of 41)

Make
Volkswagen
Model
Passat Sedan
Engine
V6-3.6L (BLV)
Year
2008
Section
Sensors and Switches - Computers and Control Systems › Oxygen Sensor › Testing and Inspection
Powertrain ManagementHO2S Front Oxygen Sensor Bank 1 Sensor 1, Checking · page 31 of 41
HO2S Front Oxygen Sensor Bank 1 Sensor 1, Checking (page 31 of 41) – Volkswagen Passat Sedan V6-3.6L (BLV) (2008)

If the specification was not obtained:

-

Replace HO2S Oxygen Sensor Bank 1 Sensor 1 (G39). Refer to the Repair Information.

If the specification was obtained:

Checking voltage supply

 Start the engine.

-

Using a multimeter, check the Oxygen Sensor Heater Bank 1 Sensor 1 (Z19) electrical harness connector terminal to ground for voltage.

Specified value: above 9.5 V.

 Switch the engine off.

If the specification was not obtained:

-

Check the HO2S Oxygen Sensor Bank 1 Sensor 1 (G39) electrical harness connector terminal 4 to fuse 33 in Fuse Panel B for high resistance, a
short to ground, or an open circuit.

-

Check the electrical harness connector for damage, corrosion, loose or broken terminals.

-

If necessary, repair the faulty wiring connection.

If the specification was obtained:

Checking ground activation

If the manufacturers test box is being used. Perform the following step.

-

Install the test box.

If the manufacturers test box is not being used. Perform the following step.

-

Remove the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.

-

Using a multimeter, check the HO2S Oxygen Sensor Bank 1 Sensor 1 (G39) electrical harness connector to the Engine Control Module (ECM)
(J623) electrical harness connector T94 terminal for resistance.

Pinch or Ctrl + scroll to zoom. Double-tap to reset.

The same page in: Passat Sedan 4Motion V6-3.6L (BLV) (2007), Passat Sedan 4Motion V6-3.6L (BLV) (2007), Passat Sedan V6-3.6L (BLV) (2008), Passat V6-3.6L (BLV) (2006), Passat V6-3.6L (BLV) (2006), Passat Wagon V6-3.6L (BLV) (2007), Passat Wagon V6-3.6L (BLV) (2007).

Parts & tools for this job For 2008 Volkswagen Passat 3.6L

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.