Passat Sedan V6-3.6L (BLV) (2008)
-
Remove positioning motor - A - from air intake shroud.
‹› Connection between control motor toothed gears and air flow door is designed so that control motor can be removed without difficulty only in the
" fresh air mode" position.
‹› If motor is found in a different position and can no longer be moved, motor cannot be simply pulled off, rather it must be loosened first with great
force from mounting points - B -, ensure that toothed gear - C - is not damaged when doing this.
Installing
‹› Motor as replacement part is delivered in the "fresh air mode " position, only when toothed gear - A - contacts stop - B - can it then be connected
onto toothed gear of fresh/recirculating air door. If a motor was removed in a different position or activated in the removed state, it cannot be
installed.
‹› If toothed gear - A - of motor does not stand at stop - B - "fresh air mode", proceed as follows:
-
Connect motor to vehicle wiring harness.
-
Switch ignition on.
-
Wait until toothed gear - A - of motor reaches stop - B - "fresh air mode".
-
Switch off ignition.