Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Starting and Charging > Charging System > Alternator > Alternator Pulley > Component Information > Service and Repair > Ribbed Belt Pulley Without Freewheel > Page 4814

Page 1
background image

Alternator Pulley: Service and Repair
Ribbed Belt Pulley With Freewheel, Valeo

Ribbed Belt Pulley With Freewheel, Valeo

CAUTION:  When disconnecting and connecting battery, the procedure must be followed as described.

NOTE:  Test the generator.

Special tools, testers and auxiliary items required

-

Multi-point adapter VAS 3400

-

Torque wrench V.A.G 1332

-

TORX screwdriver insert V.A.G 1603/1

Removing:

-

Remove generator.

-

Tighten the generator in a vise at the attachment points.

-

Remove protective cap from ribbed belt pulley with freewheel.

-

Insert multi-point adapter VAS 3400 into ribbed belt pulley with freewheel of generator using open end wrench 17 mm.

-

Insert TORX screwdriver insert V.A.G 1603/1 into generator shaft.

-

Loosen the threaded connection by rotating clockwise, while counter holding with the box-end wrench.

-

Hold ribbed belt pulley with freewheel in place by hand and turn at generator drive shaft until ribbed belt pulley with freewheel can be removed.

Installing:

Install in reverse order of removal, noting the following:

-

Next, screw ribbed belt pulley with freewheel onto generator drive shaft by hand until it reaches stop.

Torque wrench V.A.G 1332 must be rearranged for installing ribbed belt pulley with freewheel as follows:

Starting and Charging > Charging System > Alternator > Alternator Pulley > Component Information > Service and Repair > Ribbed Belt Pulley Without Freewheel > Page 4814

[PREV PAGE] [NEXT PAGE]