Touareg 2 V6-3.6L (BHK) (2008)
Installation is carried out in the reverse order, when doing this note the following:
-
When installing, make sure control motor drivers - A - are pushed into retainers - B -.
-
Initiate the basic setting function with the Vehicle Diagnosis, Testing And Information System (VAS 5051B).
Defroster Door and Front Air Distribution, Manual A/C System
Door Motors
Defroster Door and Front Air Distribution, Manual A/C System
Removing
‹› The Defroster Door Motor (V107) and the Front Air Distribution Motor (V145) are located on the A/C unit on the left retaining plate.
-
Initiate control motor Basic Setting function with Diagnostic Operation System (VAS 5051B). Refer to --> [ Climatronic A/C System with
Automatic Control, Checking and Adjusting ] See: Testing and Inspection/Climatronic A/C System with Automatic Control, Checking and
Adjusting.
-
When SF appears on the left of the Climatronic operating display, switch ignition off.
‹› Control motors can only be re-installed in the service position after removal.
-
Remove lower dash panel trim.
-
Removing and installing entry and start authorization control unit.
-
Removing relay carrier and on board supply control unit.
-
Remove the retaining plate screws - 3 -.