240 L6-2383cc 2.4L DSL SOHC D24 FI (1982)
21. Clean the mating surfaces of the housings. Install new gasket.
22. Make sure the gasket in front of the brake has not been damaged when removing the clutch.
23. Install overdrive rear housing.
24. Install the seals on the two upper studs. Install spring washers and nuts. Torque to 7-16 Nm (5-12 ft lb).
25. Reconnect the solenoid ground wire.
26. Reconnect the speedometer cable at the overdrive.Torque to 46 Nm (34 ft lb).
27. Reconnect the drive shaft at the overdrive flange.
28. Fill with correct oil, see "Specifications" for more information. Start the engine and engage the over-drive when driving. Recheck oil level after
driving.
Cleaning Oil (Fine) Filter
1. Remove oil pan and strainer.
2. Use wrench P/N 2856 to remove the plug. Remove seal and oil filter. Discard seal.
3. Clean all parts in solvent. Blow clean and dry with compressed air.
4. Install oil filter, new seal and plug. Torque to 19-24 Nm (14-18 ft lb).
5. Use a new gasket and install strainer and oil pan. Do not forget the magnet. Fill with oil see Specifications.
Cleaning Control Orifice