740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
/Page-298003.png)
Tighten bolts from center outwards.
Reconnect following hoses/lines:
- vacuum servo
- EVAP valve (F engines only)
- oil trap
- idling (air control) valve
- vacuum tank (applies only to cars equipped with CU/CU + AC heater)
Install fuel distribution pipe and injectors
Inspect injector 0-rings. Lubricate 0-rings with water-free vaseline.
Position injector wiring between No.2 and No.3 cylinder connections.
Reconnect injector connectors.
Attach and tighten fuel distribution pipe and earth leads to intake manifold.
Reconnect fuel pressure regulator line to intake manifold.
Install throttle pulley
Position pushrod under upper mounting points. Tighten support under manifold and at engine mounting.