940 L4-2.3L SOHC VIN 88 B230F (1992)
Release locking clip (1) and carefully pry out microswitch (2) with round-nose pliers.
Note:
Since microswitch is mounted on guide pin in lock housing, do not force switch sideways.
Remove microswitch from lock housing and disconnect leads from connector. (Black lead is located in slot 8 and red-green lead in slot 1).
Install microswitch
Apply light coating of contact cement to contact surfaces between lock housing and microswitch. Locate microswitch in position, ensuring that it is
securely held by locking clip and two guides in housing. Reconnect leads to connector. (Black lead in slot 8 and red-green lead in slot 1)
Close lock unit
Reinstall wiring and connector in original locations.
Refit cover.
Installation of lock
Reinstall lock unit
Place lock in position and tighten three mounting bolts. Attach link to handle and fold over locking tab (1).
Adjust link rod
Open trunk and turn key to service position.
Remove cover over right-hand tail light.
Pull back trunk lid panel to expose lock mechanism.
Open clip in link between lock and lock cylinder.
Free link section (A) from clip.