940 L4-2.3L SOHC VIN 88 B230F (1992)
Remove fabric
-
Pull fabric away from panel.
Removal of edge moulding
-
Pull moulding (A) away from large panel (see illustration).
Installation of new adhesive tape
-
Attach new double-sided adhesive tape as indicated by shaded areas in illustration.
Note:
Black areas indicate where tape is to be attached later.
Installation of new moulding
-
Install new moulding, start at point (A). Ensure that moulding is well fitted at corners and that ends meet at (A).
Attachment of new fabric to smaller panel
-
Stretch and fold fabric around edges in order shown (A, B, C) and press hard into position against tape.
Note:
(B) refers only to corner pieces. Tape should be covered completely by fabric.