940 L4-2.3L SOHC VIN 88 B230F (1992)
Place sunroof headlining in frame (foremost position).
Note: Make sure that headlining guide clips are correctly positioned.
Fit frame in vehicle.
Slide frame into base plate.
Make sure that guides in frame rear edge engage in their holes.
Align wind deflector brackets.
Tighten frame retaining screws in base plate.
Install wind deflector.
Place control mechanisms in neutral position (see picture).
Check that line-up mark is opposite center of pivot pin. If not, detach gear assembly and adjust cables as required.
Manual sunroof: Install cover and crank.
Power sunroof: Install cover over motor.