940 L4-2.3L SOHC VIN 88 B230F (1992)
- Clip cable to torque rod bracket.
Note: Cable should move freely in secured clip.
AF13
- Install cable:
‹› Run cable through sleeve bracket on rear axle and through brake shield. Install rubber gaiter. Check that gaiter is positioned securely.
AF14
- Lubricate operating lever pivot and brake shoe sliding surfaces.
‹› Use thin coating of heat-resistant graphite grease. Connect cable to lever.
AF15
- Insert cable and locate operating lever in position behind rear axle flange.
Note: Arrow on lever should point upward.
AF16