940 L4-2.3L SOHC VIN 88 B230F (1992)
Run a feeler gauge all the way around in the gap. Clearance should be between 0.3 and 0.5 mm. 0.3 mm should pass all around the gap.
If the clearance is not between the given values, use shims to adjust clearance until it does.
Shims are available in the following dimensions:
^
0.2 mm
^
0.3 mm
^
1.0 mm
Work after checking clearance
Install diode.
Connect connector.
Install:
-
splash guard under engine
Lower the car.
Install:
-
drive belt
-
mounting arms
Tension drive belt and tighten the compressor.
Install:
-
air cleaner (ACL) assembly
-
preheating hose
