Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Relay > Component Information > Testing and Inspection > Bendix > Page 4385

Page 3
background image

Checking Pin 9

8.

Check fuel pump relay (part of system relay) by connecting a lead between ground and pin 20 of the fuel injection ECU connector.

9.

Voltmeter must be connected between pin 9 and ground.

10.

Pump relay should close and run fuel pumps.

a. If fuel pumps start operating, relay is O.K.. Proceed with step 12. 
b. If fuel pumps don't run, check relay wiring, fuses and fuel pump wiring and connectors. Repair or replace as necessary.   

If wiring, fuses and connectors are in good condition, replace system relay and retest.

11.

Disconnect voltmeter and leads from pins 9, 20 and 21.

Reconnecting The ECU Connector

12.

Remove the #1 fuse and reconnect the ECU connector. Ensure that the rubber seal in the connector is installed before it is connected to the ECU. 

13.

Reinstall the #1 fuse.

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Relay > Component Information > Testing and Inspection > Bendix > Page 4385

[PREV PAGE] [NEXT PAGE]