Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Relay > Component Information > Testing and Inspection > Bendix > Page 4386

Page 1
background image

Fuel Pump Relay: Testing and Inspection
Bosch

NOTE: While trouble shooting, always check the wiring, fuses and connectors for good condition and routing. Use the wiring diagrams found in 

CHASSIS ELECTRICAL DIAGRAMS to supplement your testing efforts.
Wire colors may change during production cycle of vehicle, for testing rely on connector pin or terminal numbers.

Color Code Legend

Checking ECU Ground Connections

1.

Turn ignition OFF.

2.

Access fuel injection ECU by removing the passenger side kick panel and glove compartment.

3.

Check fuel injection ECU ground connections. They should make good contact and fit tight.

Removing ECU Connector

4.

Remove fuse #1 (located in central electric unit behind ash tray) to interrupt the power supply. Then remove the ECU connector by pressing up the
latch and folding out the wire cluster.

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Relay > Component Information > Testing and Inspection > Bendix > Page 4386

[PREV PAGE] [NEXT PAGE]