Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Testing and Inspection > Bendix > Page 4500

Page 3
background image

Measuring High Voltage Side Of Coil

13.

Measure resistance between HT terminal and each LT terminal as shown in the figure.

Reading: approx. 5 K ohms

If reading is different, replace and retest with new coil.

Checking "A" Terminal At Three Wire Connector

14.

Turn ignition ON.

15.

Measure voltage between terminal "A" at three wire connector and ground.

Reading: approx. 12 volts

If there is no or low voltage, check blue wire to ignition switch and ignition control ECU connector pin 6. Repair as needed. If no voltage is
available at ignition switch, check switch (see IGNITION SWITCH).

16.

Crank engine.

Reading: no less then 10.5 volts

If reading is different, check battery and terminals. Repair as needed.

17.

Turn ignition OFF.

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Testing and Inspection > Bendix > Page 4500

[PREV PAGE] [NEXT PAGE]