Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Crankshaft Position/Engine Speed Sensor <--> [Crankshaft Position Sensor] > Component Information > Technical Service Bulletins > RPM Sensor - Improved > Page 4865

Page 2
background image

Remove RPM sensor connector at the firewall.

Remove the RPM sensor from the bracket on the gearbox.

Install the new RPM sensor. Torque to 8 N-m (6 ft.lbs).

Install the small clip, P/N 3549774-8, on the coolant pipe and the large one, P/N 9146999-9, on the hose.

Install the RPM sensor cable in the clips as shown in the picture.

Check connectors

The connector sections should be greased. If they are not greased, spray rust solvent P/N 1161435-1 onto the connector halves.

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Ignition System > Crankshaft Position/Engine Speed Sensor <--> [Crankshaft Position Sensor] > Component Information > Technical Service Bulletins > RPM Sensor - Improved > Page 4865

[PREV PAGE] [NEXT PAGE]