Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Testing and Inspection > Bendix > Page 1098

Page 2
background image

Checking Coil

5.

If resistance is: 

a. to low, replace ignition coil and retest.
b. to high, check resistance between coil terminals 1 and 15. Reading still to high, replace coil and retest. Reading correct, repair fault in wiring

or connectors.

Checking Coil Primary Winding

6.

Check ignition coil secondary winding by connecting an ohmmeter between coil terminals 1 and high-voltage outlet.

Reading: 6.5 - 9.0 K ohms

7.

If not, replace ignition coil and retest.

Checking Power Stage Ground

8.

Check power stage ground wire by connecting the ohmmeter between pin 2 (black) and ground.

Reading: 0 ohm

9.

If not, repair fault in wiring or connectors.

Checking Pin 3 And 5

10.

Check that wire screen is properly connected to pin 3 (gray).

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Testing and Inspection > Bendix > Page 1098

[PREV PAGE] [NEXT PAGE]