Volvo Workshop Manuals
940 L4-2.3L SOHC VIN 88 B230F (1992)
Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Crankshaft Position/Engine Speed Sensor <--> [Crankshaft Position Sensor] > Component Information > Testing and Inspection > Ignition ECM > Page 2089
Removing Protective Sleeve
Remove connector protective sleeve and reinstall fuse #1 for testing.
^ Check connections through the holes in the connector.
Checking Pin 1
Check RPM sensor lead from ignition ECU by connecting a voltmeter from pin 1 on fuel injection ECU connector to ground.
Run starter motor.
Reading: over 5 volts
If reading is different, check wiring and connections. Fix as necessary. If wiring and connections are O.K., check ignition ECU (see ON-BOARD
Turn ignition OFF.
Disconnect the test equipment. Remove the #1 fuse and reconnect the ECU and all other connectors, install the kick panel and glove compartment.
Reinstall the #1 fuse.
|[PREV PAGE] [NEXT PAGE]|