940 L4-2.3L SOHC VIN 88 B230F (1992)
Self-lubricating bushings do not wear significantly if they are treated correctly before installation.
Treating new bushings:
-
place thumb over end of bushing
-
fill bushing with engine oil
-
using index finger, press to force oil out through pores.
-
Place bearing housing on a suitable support and tap out worn bushing.
-
Clean bushing hole, filing any rough surfaces.
-
Press in new bushing with a suitable drift.
M14 Control solenoid
Test solenoid with an ohmmeter or buzzer. Make sure that current flows between terminal 50 and ground. Then test between terminal 50 and field coil
terminal "M". If current does not flow there is an open circuit in the solenoid. The solenoid must therefore be replaced.
M15 Starter body
