940 L4-2.3L SOHC VIN 88 B230F (1992)
Trailing Arm: Service and Repair
1.
Raise and support vehicle. Support front end under control arm brackets so the vehicle will not be front heavy and the rear springs difficult to
compress.
2.
Remove rear wheel and brake caliper assembly. Hang caliper from rear spring.
3.
Remove propeller shaft rear flange attaching bolts and lower the shaft slightly.
4.
Support trailing arm with a suitable jack, then remove roll bar attaching bolts on both sides.
5.
Remove shock absorber lower bolt on side trailing arm is being removed and loosen bolt on opposite side, then slowly lower rear axle to unload
springs.
6.
Loosen bracket nuts crosswise, then remove rear bracket and rubber supports.
7.
Remove bolts from front bracket, nut and bracket, then the trailing arm.
8.
Replace bushing using drift 2704, support 5082 and a hydraulic press. Bushing tapered hole should face upward and bushing must be evenly
spaced in arm.
9.
Reverse removal procedure to install. Tighten fasteners to specifications.
