940 L4-2.3L SOHC VIN 88 B230F (1992)
2. Remove retainer 5076 and tighten screws. Tighten alternately. Torque: 8-12 Nm (6-9 ft.lb).
3. Connect kickdown cable to throttle pulley. Adjust cable. refer to "Installation". See: Throttle Valve Cable (Kickdown Cable)/Service and Repair
Oil Strainer
4. Install oil strainer and tighten screws. Torque: 56 Nm (3.5-4.5 ft.lb).
5. Install particle magnet(s). Magnets are installed under strainer in sump.
6. Install control system oil pipes.
NOTE: Three pipes in transmission with kickdown inhibitor.
7. Install oil sump with new gasket. Torque: 4-5 Nm (3-3.5 ft.lb).
8. Install fluid filler tube. Torque: 80-100 Nm (59-74 ft.lb).
9. Fill transmission with fluid.
