940 L4-2.3L SOHC VIN 88 B230F (1992)
NOTE: Type P: Proceed to operation 13.Operations G6 to 12 only refer to Type J.
6. Before installing one-way clutch:
-
Make sure thrust washer is correctly positioned.
-
If thrust washer is replaced, make sure that it is correctly positioned. It should be 0.6 mm (0.024 in) above edge.
7. Correct thrust washers:
-
Use thickness 2.5 mm (0.1 in), P/N 380 715-3, for early version of output shaft, P/N 380 679-1 and P/N 1 232 105-5.
-
Use thickness 3.8 mm (0.15 in), P/N 1 232 644-4, for output shaft P/N 1 232 646-3.
8. Install one-way clutch hub and roller cage with rollers.
9. Install oil slinger and lock ring. Check that one-way clutch functions correctly.