940 L4-2.3L SOHC VIN 88 B230F (1992)
10. Install drive flange. Apply locking fluid, P/N 1161 075-5, to splines. Be careful not to apply to seal. Use press tool P/N 1845 if required.
11. Install nut. Torque to 175 Nm (130 ft lb.).
-
Round drive flange: use wrench P/N 5149.
-
Three-arm drive flange: clamp drive flange in a vice.
12. Install planetary gear on output shaft. Guide splines into carrier and one-way clutch hub. Use centering drift P/N 2835.
NOTE: Proceed to operation 18. Operations 13 to 17 only apply to Type P.
13. Install drive flange. Apply locking compound, P/N 1161 075-5, to splines. Be careful not to apply to seal. Use press tool P/N 1845 if required.
14. Install nut. Torque to 175 Nm (130 ft lb).
-
Round drive flange: use wrench P/N 5149.
-
Three-arm drive flange: clamp drive flange in a vice.
