940 L4-2.3L SOHC VIN 88 B230F (1992)
29. Assemble rear and front housings.
NOTE: Make sure gasket fitted between brake drum and rear housing is installed.
Remove remains of old nylon washers from two upper bolts on rear housing. Install new nylon washers, small end towards rear housing. Torque
nuts in stages to 12 Nm (9 ft ft lb).
30. Install bridges. Torque nuts to 10 Nm (7 ft lb).
31. Install solenoid. Attach ground wire. Use crow-foot wrench P/N 5172. Torque to 50 Nm (37 ft lb).
Installation
1. Fit the overdrive onto the gearbox output shaft and tighten the nuts.
2. Fit the gearbox cross-member.
3. Connect the cables to the solenoid. Connect the connector for the torque limiter monitoring function.
4. Fit the propeller shaft.
5. Top up with oil.
6. Check the operation of the overdrive with the rear wheels of the car jacked up.
7. Check the oil level.
Replacing Oil Seal at Output Shaft
