940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Method For Version 3 (C)
Applies to:
940, 1993
4-door models as from chassis No. 114465
5-door models as from chassis No. 066167
Note:
Unlike earlier models, the power seats in the above models can be operated with the ignition off.
Procedures in Part I are valid for cars built up to chassis numbers listed below. Procedures for Part II are valid for cars after these chassis numbers:
4 door models:
124126 Factory Code 0
123549 Factory Code 1
123609 Factory Code 3
122175 Factory Code A
5 door models:
073706 Factory Code 0
074106 Factory Code 1
074202 Factory Code 3
072508 Factory Code A
C1
-
Switch off ignition.
C2
I. -
Manual fault tracing/calibration: Connect auxiliary lead (alternative 1 or 2 as illustrated) between connector at front of seat to be tested and test
lead on DLC A.
-
Fault tracing/calibration using VST with OBD System Memory Cassette: Connect auxiliary lead to terminal 6 on the VST adapter cable.
II. -
Manual fault tracing/calibration: Connect test lead from DLC A to socket 6 on DLC B.
-
Fault tracing/calibration using VST with OBD System Memory Cassette: Connect instrument to DLC B.
C3
-
Remove fuse No. 3
Fusebox is located behind ashtray in center console, in front of gear lever.
C4
Ignition must be off for at least 5 seconds before performing this step.