940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Removal of trim
-
Cut off clamps which hold trim under seatback.
-
Carefully lift trim so that motor is accessible.
-
Slacken off elastic retainers if necessary.
Removal
Remove:
-
Plastic holders for tilt support and slacken off.
-
Nut which holds lower motor bracket to seatback frame.
-
Motor
-
Drive cables from motor and drive gear
-
Any clips holding cable against upholstery.
Replace:
Replacement
-
Replace drive cables in motors and drive gear.
-
Tighten screw for cable locking plate (1).
Feed in motor upper bracket
-
Feed motor upper bracket into hole in frame.
Tightening nut
-
Tighten nut which holds lower bracket to seatback frame (2).
Fixing drive cable