940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
10.
Attach diaphragm rod to wastegate valve shaft.
11.
Install diaphragm rod clip.
12.
Install exhaust pipe to turbo charger, start nuts but do not tighten. Use anti-seize on studs.
13.
Install bell housing clamp and tighten.
14.
Tighten exhaust pipe to turbo charger nuts, torque to:
18 ft.lb (25 Nm)
15.
Tighten catalytic converter to exhaust pipe bolts.
16.
Run engine and check boost pressure, refer to TURBO BOOST PRESSURE TEST under TESTING PROCEDURES.