940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
6. Tap in new seal Use handle 1301 and drift 5347. Lubricate seal. Pack space between lips of seal with grease.
7. Install/press in inner drive (axle) shaft. Ensure that shaft engages locking ring groove.
8. Install:
-
outer drive (axle) shaft. Ensure that mating surfaces are free of dirt.
-
bolts holding inner and outer drive (axle) shafts. Use new, well oiled bolts. Tighten to 30 Nm (22 ft. lbs.) and angle tighten through 90
degrees. Alternatively, torque to 65-75 Nm (48-55 ft. lbs.).
9. Insert two M12 bolts or 12 mm drifts in rear axle member centering holes
NOTE: This is essential to ensure that wheel alignment is correct after assembly.
10. Tighten bolts securing upper and lower sections of rear axle member. Tighten to 70 Nm (52 ft. lbs.) and angle tighten through 30 degrees.
11. Lower car