940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Note length of bolts and mark positions with felt pen. Also mark position of universal joint in relation to drive flange before disconnecting propeller
shaft from flange.
Disconnect/remove:
-
propeller shaft from front drive flange.
Use socket 999 5244
-
one tank support bolt. Twist support to one side.
-
propeller shaft from rear drive flange. Use tool 999 5561 as counterhold.
Remove:
-
bolts (two) holding propeller shaft intermediate bearing
-
bolts (four) holding intermediate bearing support
Note!
Retain washer between bearing and support.
-
propeller shaft from car by pulling shaft forward
Replacement of Seal/Pinion
Replacement of seal/pinion