940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Wiper Motor: Service and Repair
Front Wiper Linkage and Motor Replacement
-
Disconnect battery negative lead.
-
Remove wiper arms.
-
Remove rubber seals (1).
-
Open hood fully.
-
Release water hoses from clips (2). Remove the three screws (3) retaining the cover panel. Older models have plastic clips at the ends instead of
screws.
-
Open hood fully.
-
Remove cover plate by pulling forward slightly and then lifting back and up.
Exercise care to avoid damage to paintwork.
Close hood.
-
Undo four retaining screws (4) for the wiper linkage.
One of the screws is concealed beneath a rubber plug (5) in cover (6).
-
Remove cover from wiper motor.
-
Cut off cable tie (7) and unplug connector (8).
Unscrew ground lead.
-
Lift out wiper linkage.
-
Unscrew the motor axle nut or screw (10) plus the three screws (9) retaining the motor, and lift out the motor (11).
-
Reassemble in reverse order.
Check that spacers are in position before the screws (4) are replaced.
NOTE: Always check that the axles on the old motor and the new are identical.