C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Oil Pan: Procedures
Oil Sump Replacement
Special Tools: 951 1205
Preparation
-
Remove
-
the oil dipstick and its pipe.
-
the splashguard under the engine.
-
Drain the engine oil and remove the oil filter.
-
Release the oil cooler from the sump. Hang up at the rear.
-
Remove the screw from the bracket for the fuel line.
Removing The Oil Sump
-
Slacken off all screws holding the oil sump.
-
Remove all screw except for four. It is recommended that the four screws in the corners of the sump are left in place.
-
Carefully tap the sump with a rubber mallet until the joint and its liquid gasket releases.
-
Remove the four remaining screws.
-
Remove the sump.
Cleaning
Clean the gasket surfaces on the oil sump and cylinder block. Use a razor blade or a gasket scraper and gasket solvent P/N 1161 440.
WARNING: Use a fume hood or extractor when using gasket solvent.
Installing The Oil Pan